Installation
Please install the product following the method below.
1. Install the electrostatic sticker
Clean your windshield and put the electrostatic sticker on the
recommended area as shown in the figure below.
Make sure you remove air bubbles between the sticker and the
glass.
2. Install the bracket
Lock the bracket to the Dash Cam, as shown in the figure below.
You will hear a snap when it is in place.
3. Stick the camera mount to the windshield
Remove the protective cover from the mount and stick the
mount's base to the center of the electrostatic sticker. Make sure
your dash cam body is parallel to the ground.
Press the mount to attach it to the electrostatic sticker tightly.
3
Autogoods "130"