Tool Parts - Porter Cable FC350A Instructivo De Operación

Fig. 1
A. Exhaust deflector
B. Selectable trigger
C. Air Inlet with quick
connect coupler
D. Magazine
E. Nail follower
F. Safety contact trip
with No-mar pad
G. Depth adjustment
wheel
H. Pusher release
I. Pusher
Disconnect air line from tool and remove fasteners from magazine
before making adjustments or personal injury may result.
trIGGer
Keep fingers AWAY from trigger when not driving fasteners to avoid
accidental firing. Never carry tool with finger on trigger. In bump action mode (contact
actuation mode) tool will fire a fastener if safety is bumped while trigger is depressed.
The FC350A is equipped with a selectable trigger. This trigger allows the operator to
select either single sequential action trigger mode or bump action trigger mode. In
accordance with the ANSI Standard SNT-101-2002, the trigger is assembled in the single
sequential action trigger mode. To change the trigger mode, see actuating tool instruc-
tions in the Operation section of the manual.
Important: A trigger, which will limit the tool to sequential actuation only, is
available free-of-charge by calling 1-800-321-9443 in the United States and Canada
or 001-731-660-9374 outside the United States and Canada, and providing tool
model number, type, serial number, etc. For identification purposes: the sequential
actuation trigger is red.

tool partS

a
G
f
H
aSSemBly
B
I
7 - ENG
c
e
D