Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Opecat[on
8.
Start engine
according
to instructions
given in engine
owner's
manuaLAHso
see
operating
instructions
tag
Hocated
on the
pressure
washer.
. When
starting
engine,
pull cord slowly
until resistance
is felt
and then
pull rapidly to avoid kickback.
. Hfengine starts
and fails to continue
to run or if increased
resistance
is felt during
starting
pull attempts,
squeeze
trigger
on spray gun_
NOTE;
Always
keep the
throttle
lever
in the
"Fast"
_osition
when
operating
the
pressure
washer.
WARNING
. DO NOT touch hot surfaces.
Allow equipment
to coot before touching.
. The pressure washer must be at least 5 feet from structures
having combustible
wails and/or other combustible
materials.
. Keep at least 3 feet of clearance on all sides of pressure
washer
for adequate cooling, maintenance
and servicing.
. Hnthe State of California
a spark arrester
is required
by law
(Section 4442 of the California
PuNic Resources Code). Other
states
may have similar laws. Federal
laws apply on federal
lands_ [f you equip the muffler
with a spark arresten it must be
maintained
in effective working
order:
How to Stop Your Pressure
Washer
H.
Let engine
idHe for two
minutes.
2.
Turn
engine off according
to instructions
given
in
engine owner's manual
3.
Squeeze
trigger
on
spray
gun
to
remieve
trapped
pressure
in hose
to
avoid
iniury.
NOTE:
A smaHH amount
of water
wiHHsquirt
out when
pressure
is reHeased.
WARNING
Keep high pressure hose connected
to pump and spray gun
while system is pressurized_
Squeeze triter
on spray gun to relieve trapped pressure,
every time you stop engine. Engage trifler
lock on spray gun_
4.
Engage
trigger
Hock on spray
gun when
not
in use.
The unit is equipped with an accessory tray with pHacesto
store your spray gun, nozzHe extension, turbo nozzHe,and
ProiectPro TM nozzHes.There is aHsoa hook at the front of
the accessory tray to hoHd your high pressure hose.
NOTE:The
extra hoHe in the tray is for storing a utility
brush.The brush is NOT
incHuded with your pressure
washer.You can buy the brush as an optionaH accessory.
H.
PHacenozzHe extension
through hoHe on accessory tray,
as shown in Figure H2.
2.
PHacespray gun through hoHe on accessory tray on
right side of unit (Figure H 2).
NOTE:You
may aHsouse the hooks attached to the base
and handHe to store your gun and nozzHe extension, as
shown on page 5.
3.
Push turbo nozzHe up and into chip on accessory tray
untiH it snaps in, as shown in Figure H 2.
4.
Hang high pressure hose on hook attached to accessory
tray on front of tray, as shown in Figure H 2.
Publicidad
Tabla de contenido
