Troy-Bilt 020245 Instrucciones De Uso página 14

SPECmFmCATmONS
_ax outmet
Pressure
..................... ")200 psi
Max [::mowRate .......... 2.2 gallons per minute (gpm)
Detergent Use detergentapproved forpressurewashers
Water
Suppmy
................ Not to Exceed IO0°F
Automatic coom ............. Will cycle when water
Down System reaches 125°° 155°F
Shipping Weight ........................... 54 Ibs.
GENERAL HAmNTENANCE
RECOHHENDATmONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
recove full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE: Should you have questions about replacing
components on your TroyoBilt pressure washer, please call
1=888-611=6708 for assistance.
o Some adjustments will need to be made periodically to
properly maintain your pressure washer.
o All maintenance in this manual and the engine owner's
manual should be made at least once each season.
o Once a year you should clean or replace the spark plug,
clean or replace the air filter and check the spray gun and
nozzle extension assemblyfor wear.A new spark plug and
clean air filter assure proper fuebair mixture and help your
engine run better and last longer. Please refer to your
engine owner's manual for more details.
o If equipped with inflatable tires, keep the air pressure at
the value marked on the tire or within I S and 40 psi.
Before
Each Use
° Check engine oil level.
o Check water inlet screen for damage.
o Check in=line filter for damage.
o Check high pressure hose for leaks.
o Check chemical injection hose and filter for damage.
° Check spray gun and nozzle extension assembly for
leaks.
o Rinse out garden hose to flush out debris.
PRESSURE
WASHER
MAmNTENANCE
Check and Clean
InletScreen
Examine the screen on the pump's water inlet. Clean it if
the screen is clogged or replace it if screen is damaged,
Check High Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
it. Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. If any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose. Replace it,
Replacement hose rating NUST exceed maximum pressure
rating of unit.
Check Chemical lniection Hose
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears. Replace the filter or
tube if either
is damaged.
Check
Gun and Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the trigger lock in the ON position and test the trigger.
You should not be able to press the trigger.
Check In-Line
Filter
Refer to Figure 19 and service the in-line filter if it
becomes clogged, as follows:
Nozzle Extension
O:ring