Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Storage
PREPARING
THE
fJNmT
FOP, STORAGE
VVater shouHd not remain in the unit for Hong periods of
time. Sediments or mineraHs can deposit on pump parts and
"freeze" pump action. If you do not pHanto use the pressure
washer for more than 30 days_follow this procedure:
H. Hush chemicaH injection hose by pHadng fiker into a paiH
of dean water whiHe running pressure washer in How
pressure mode. Hush for one to two minutes.
2.
Shut off engine and Het it cool then remove high
pressure and garden hoses. Disconnect
spark pHugwire
from spark pHug.
3.
Empty pump of aHH pumped Hiquids by puHHing recoiH
handHe about 6 times.This
shouHd remove most Hiquid
in pump.
4.
Use PumpSaver to prevent corrosion
buiHd up and
freezing of pump.
5.
Store unit in a cHean_ dry area.
Protecting
the
Pump
To protect
the pump from damage caused by mineral
deposits or freezing, use PumpSaver, HodeH 6039, to treat
pump.This
prevents freeze damage and Hubricates pistons
and seaHs.
NOTE:
PumpSaver is avaHabHe as an opt[onaH accessory. [t
is not incHuded with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver_
• Failure to do so will permanentJy
damage your pump and
render your unit inoperable,
Freeze damage is not covered under warranty.
CAUTION
AJways wear eye protection
when using PumpSaven
Protect surfacesfrom dripping PumpSaven
To use PumpSaven make sure the pressure washer is
turned off and disconnected
from suppH7water. Read and
follow aHH instructions
and warnings given on the PumpSaver
container.
NOTE:
[f PumpSaver [s not avaHabHe_ d raw RV antifreeze
(non=aHcohoH)into the pump by pouring the soHut[on into a
3=foot section of garden hose connected to inHet adapter
and puHHing recoiH handHe twice.
STORING
THE ENGINE
See the engine
owner's
manual
for instructions
on how
to
properHy
prepare
the engine
for storage.
Publicidad
Tabla de contenido
