Troubleshooting; Safety Instructions - Velleman TRC1 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

4. To lift off and climb: pull the trigger (#11). The harder you pull, the faster the rotor rotates, and the higher the
helicopter flies. The flight speed is indicated on the remote control by the red LEDs (#9).
5. To change direction: gently ease off on the trigger ; the helicopter's tail rotor will make the helicopter turn to the
right.
! It is not possible to accurately pre-select a right or left turn.
direction, pull the trigger harder again
6. To land: an ideal landing surface is a soft grassy area. Harsh landing surfaces may damage the helicopter. To
land, ease off on the trigger slowly. Do not ease off too fast, as this may cause your helicopter to come down too
fast and possibly crash or be seriously damaged.
7. To stop the rotor from spinning and retrieve the helicopter: push the trigger outwards to brake, and keep it pushed
to keep the rotor from spinning. Set the helicopter's on/off switch (#4) to off.
8. Always switch off the helicopter, remote control and charger when they're not being used to prolong battery life.

5. Troubleshooting

PROBLEM
No power to remote control or helipad
Charge nozzle cannot be inserted
Red charging LED does not light up
No control over helicopter
Helicopter is not flying high enough
Helicopter does not turn left/right
Helicopter lands too quickly
Main rotor keeps on spinning

6. Safety Instructions

• Damage caused by user modifications or by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
• Keep the device away from unauthorised users.
• Use the original packaging if the device is not being used or is to be transported.
• This device must not cause harmful interference and should not be influenced by outside interference.
• Keep away from the helicopter as long as the rotors are in motion.
• Do not launch the helicopter or fly near other people, animals or other objects
• Do not fly in windy conditions, bad weather or extreme temperatures .
• Always launch the helicopter from the helipad. Do not attempt to hand launch the helicopter.
• Do not pull the trigger on the remote control while switching on the helicopter!
• If any of the rotor blades are damaged, do not fly the helicopter and have them replaced.
• Do not push the trigger on the remote control all the way forward during flight, for this will stop the rotors from
spinning completely, causing the helicopter to fall down. Only push the trigger to stop the rotors when the
helicopter is on the ground or in case of an emergency.
• Use an external adapter with a max. current of 800mA to protect the batteries and avoid personal injury
The information in this manual is subject to change without prior notice.
TRC1
.
CAUSE
Power switch set to 'off'.
Incorrect battery polarity
Batteries are drained
Helicopter on/off switch is set to 'on'
Nozzle is not inserted all the way
Charger on/off switch is set to 'off'
Charging button is not pressed
Remote control is not on
Antenna not fully extended
Too much wind
Rotor speed is too slow
Helicopter is not fully charged
Batteries in charger are drained
No left/right toggle
Trigger is eased off on to fast
Trigger not pushed all the way out
- 3 -
When the helicopter is pointing in the desired
Set power switch to 'on'
Verify battery polarity
Install new batteries
Set the switch to 'off' to reveal the connector
Insert the nozzle entirely
Set charger switch to 'on'
Press the charging button
Switch the remote control on
Extend the antenna completely
Do not fly in wind
Pull the trigger harder
Fully charge the helicopter
Install new batteries in charger
see 'c. Flying the helicopter' above
Slowly ease off on the trigger
Push trigger all the way out
SOLUTION
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido