Allmatic AX100 24V Manual Del Usuario página 7

A en on!
This manual is for qualified installers only and not for the final user. It is the
•
installer's job to explain to the user how the automa sm works, about
hazards related to it and the necessity for periodical maintenance.
The installa on must be carried out by qualified personnel only, observing
•
current standards concerning automa c closing systems. More specifically,
installa on conformity calls for the observance of direc ve 89/392 and
standards EN 12453 and EN 12445.
Make absolutely certain that the power is disconnected before carrying out
•
any work on the device.
The power lead must only be connected to supply lines fi ed with adequate
•
electrical protec on; a circuit breaker must also be installed to guarantee the
disconnec on of all the phases from the mains with a distance of at least 3.5
mm between the contacts.
Be par cularly careful when evalua ng the safety devices to install and their
•
loca on. Always install an emergency stop device that will cut the power off in
case of necessity.
Use original components only. Allma c is not liable for damages if any other
•
components are used.
Do not work on the device if your hands or feet are damp or wet and do not
•
leave it exposed to the weather.
This device must be used only for the purpose it has been expressly designed;
•
any other use is considered improper and therefore dangerous.
Only qualified technicians must be allowed to service the unit, including
•
changing the courtesy light bulb whenever this is needed.
Make sure that the gate structure is solid, well balanced, and suitable to be
•
motorised. Also ensure there are no points of fric on when the gate is
moving.
6-1624028 rev.6 05/07/2013
ITA ENG FRA ESP DEU POR
ENG
7 / 22