Maintenance; Environmental Protection - Redstone RS 10.8Li CC Instrucciones De Uso Originales

INSERTING AND REMOVING BITS (FIG. 2)
WARNING: Remove the battery or set the
forward/reverse switch (6) in central (neutral) position.
Inserting the bit:
1. Pull the locking sleeve (1) forward.
2. Insert the bit into the hexagonal socket of the bit
holder (2).
3. Release the locking sleeve. It will return in its initial
position and secure the bit.
WARNING: If the locking sleeve does not re-
turn to its original position, then the bit has not been
installed properly.
Removing the bit:
Pull the locking sleeve forward and keep it in this position
to remove the bit
SCREWING / UNSCREWING
Install a bit that matches the screw, align the bit into the
grooves of the screw head, and then tighten it.
Push the impact driver just enough to keep the bit in con-
tact with the screw head.
WARNING: Overtightening may result in
breaking the screw or damaging the bit!
Applying the impact driver for too long may tighten the
screw too much and break it.
▪ Tightening with the impact driver not aligned with the
screw may damage the screw head and the driving
force will not be transmitted properly to the screw.
▪ Before screwing large long screws into hard material,
it is advisable to pre-drill a pilot hole with the core di-
ameter of the thread to depth approx. 2/3 of the screw
length.

Maintenance

WARNING: Always set the forward/reverse
switch (4) in central position before any work on the
machine e. g. fitting and removing a battery, tool
change, transport, maintenance and storage.
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Re-lubricate all moving parts at regular intervals.
Original instructions
CLEANING
For safe operation always keep the machine and its ven-
tilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the grills near the motor and around the switch-
es. Use a soft brush to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
Charger Cleaning Instructions
WARNING: Disconnect the charger from the
AC outlet before cleaning.
▪ Dirt and grease may be removed from the exterior of
the charger using a cloth or soft non-metallic brush.
Do not use water or any cleaning solutions.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
certified service centres or other qualified service organ-
isations, always using genuine replacement parts.

Environmental protection

The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
For EU-countries only:
Do not dispose of the power tool into household
waste! According to the guidelines 2012/19/EC, power
tools, which are not usable, should be recycled.
Batteries:
Do not dispose of the power tool or the bat-
tery into household waste, fire or water. All
type of batteries should be sorted for environ-
mental-friendly recycling or destroyed.
For EU-countries only:
Defective or worn out batteries must be recycled accord-
ing to the guidelines 2006/66/EC.
17
EN