Electrical power supply
Danger: Non-compliance with these instructions could cause fatal injuries due to
electric shock!
Check that your power supply voltage corresponds to the one shown on the appliance
(alternating current only). Any error in plugging in your appliance may cause irreversible
damage and invalidate the warranty. The appliance should always be plugged into an outlet
with an earth ground connection.
Check that the outlet can be easily accessed so that the plug can be disconnected easily in
the event of a malfunction or during a thunderstorm.
For the safety of your appliance, remove the plug in the event of a thunderstorm. Do not pull
the cord to remove the plug.
Remove the plug immediately if you notice any problem during operation or if there is a
problem during the brewing cycle.
Disconnect the appliance if you are not going to use it over a long period of time and when
cleaning.
Do not use the appliance if the power cord or the appliance itself is damaged. If the power
cord or plug is damaged, the power cord must be replaced by an approved KRUPS service
center.
Do not leave the power cord overhanging a table or work surface. Do not allow your hands
or the power cord to touch hot parts of the appliance.
The power cord must never be close to or in contact with a source of heat or be allowed to
rest on sharp edges.
The use of multiple plugs or extension cords is not recommended. Any error in connection
will invalidate the warranty.
Appliance
With the exception of cleaning and descaling according to the appliance instructions, any
servicing on the appliance must be performed by an approved KRUPS service center. For
your own safety, only use approved KRUPS accessories and spare parts since these are
suitable for your appliance.
Disconnect the appliance when you leave the room or house for a long period of time.
Never open the appliance.
Caution! risk of death due to electrical current! Any unauthorized opening of the
appliance will invalidate the warranty. Do not use your appliance if it is not working
properly or if it has been damaged. In this event, it is recommended that you get the
appliance examined by an approved KRUPS service center (refer to the list in the
KRUPS service booklet).
For safety reasons, any transformation or modification of the appliance, performed
individually, is forbidden, as only tested appliances are certified and the manufacturer will
refuse all liability in the event of damage.
For safety reasons, while producing steam while making a cappuccino, heating milk or
heating water, do no put your hands under the steam nozzle or the super cappuccino
accessory, or under the coffee nozzle while making coffee.
The steam nozzle can be very hot, do not touch it during or right after use.
To avoid dirty water overflowing onto your counter top or running the risk of burning yourself,
remember to put the drip tray in place the drip tray and make sure you protect your counter
top during the descaling cycles, particularly if it is made of marble, stone or wood.
Never put ground coffee into the coffee bean hopper.
Do not put water in the coffee beans hopper.
7