Hanging The Fan; Making The Electrical Connections - Progress Lighting AirPro P250028 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly.
Attach the mounting bracket to the outlet box
1.
with two screws and washers provided with the
outlet box. Make sure the bracket is tight and
secured (Fig. 4).
2. Lift fan into position by hanging the motor
assembly onto the hook from the ceiling
mounting bracket allowing it to hang freely
(Fig. 5).
Outlet Box
Mounting Bracket
Figure 4
Making the Electrical
Connections
NOTE
TO AVOID POSSIBLE ELECTRICAL SHOCK, BE
Motor
SURE ELECTRICITY IS TURNED OFF AT THE
MAIN FUSE BOX BEFORE WIRING.
NOTE
FAN MUST BE INSTALLED AT A MAXIMUM
DISTANCE
TRANSMITTING
SIGNAL TRANSMISSION BETWEEN THE
TRANSMITTING UNIT AND THE FAN'S
RECEIVING UNIT.
Figure 5
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
This remote control unit is equipped with 16 code
combinations to prevent possible interference
from or to other remote units. The frequency
switches on your receiver and remote control have
been preset at the factory. Please recheck to make
sure the switches on the remote control and the
receiver are set to the same position. Any
combination of settings will operate the fan as long
as the switches in the remote control and receiver
are set to the same position. (Figure 6)
OF 20 FEET FROM THE
UNIT FOR PROPER
4.