Package Contents; Hardware Overview - D-Link DGS-1008P Guia De Instalacion

Before You Begin
This Quick Installation Guide gives you step-by-
step instructions for setting up your DGS-1008P
8-port Gigabit PoE Desktop Switch. The model
you have purchased may appear slightly different
from the one shown in the illustrations. For more
detailed information about the switch and technical
specifications, please refer to the User Manual.

Package Contents

This DGS-1008P package should include the
following items:
• 1 x DGS-1008P
• 1 x AC to DC power adapter with power cord
• 1 x Wall mounting kit
• 1 x Quick Installation Guide
If any of the above items are damaged or missing,
please contact your local D-Link reseller.

Hardware Overview

LED Indicators
1 2 3
4
Figure 1: Front panel LEDs
# LED Status
Solid The switch is powered on.
green
Power
1
Off The switch is turned off.
Description
# LED Status
Solid red Indicates the total PoE power
output of the switch has exceeded
the Guard Band threshold of 73
watts, but is still below the total
budget of 80 watts.
Blinking The total PoE budget of 80 watts
PoE
2 red has been exceeded. When the
Max.
switch's PoE budget is being fully
utilized, no additional devices can
be powered through the switch.
Off The total PoE power consumption
is below the 73 watts Guard Band
threshold.
Solid The port is providing power to the
green connected PoE-powered device.
Solid red The PoE power feed from this port
has failed.
Blinking Indicates a PoE-powered device
PoE
3
red is connected to this PoE port,
but the switch has insufficient
remaining power budget to
power the device.
Off There is no PoE-powered device
connected to this port.
Solid There is an active link negotiated
green at 1000 Mbps on this port.
Blinking There is traffic on the port.
green
Link/
4 ACT/ Solid There is an active link negotiated
Speed
amber at 10/100 Mbps on this port.
Blinking There is traffic on the port.
amber
Off There is no active link on this port.
Table 1: LED overview
Front Panel Connectors
Figure 2: Front panel connectors
# Interface
10/100/1000 Mbps PoE-capable
1 Ports 1 - 4 ports, used for connecting Ethernet
devices and PoE-powered devices.
10/100/1000 Mbps non-PoE ports,
used for connecting Ethernet
Ports 5 - 8
2
devices. These ports cannot power
PoE devices.
Table 2: Front connector description
Description
1 2
Description
1