Maintenance & Cleaning - Össur i-LIMB WRIST Instrucciones De Uso

50/60Hz Switch
Adjust the electrode frequency in the settings tab of the My i-Limb app. This optimizes the set-up for travelling and
different countries.
My i-Limb App
– If using an i-Limb Wrist together with an i-Limb Quantum hand, only the wrist number will be displayed in
the My i-Limb app.
– Selecting the wrist number will connect both the hand and the wrist to the My i-Limb app. The device may
beep when connected to the app.
– For smart control training, practice bars will show what muscle action is being identified by the prosthesis.
This helps show any conflicts or confusions in muscle actions. Practice can aid developing and improving
technique.
– Motion of the prosthesis can be turned on or off during practice, depending on your preference. Consult
your clinician if confusion continues without improving during practice. A re-recording may then be
advisable.
MAINTENANCE & CLEANING
Service and Maintenance
Should you experience any problems with your i-Limb Wrist rotator, please contact your certified clinician for
service and maintenance.
Always make sure to:
a. charge the battery each day;
b. regularly clean their prosthesis;
c. neither maintain nor service the i-Limb Wrist;
d. return the i-Limb Wrist annually for service and repair to Össur.
See address at end of this manual to locate a regional Össur office.
Cleaning instructions
The i-Limb Wrist is housed within your prosthesis. When the hand is not attached, you will only see the end which
connects to it. This connecting end is the co-axial post (Figure 5).
Regularly wipe and clean the co-axial post with a dry cloth. Performance issues can occur if the co-axial post is not
cleaned regularly.
Clean the electrode surface regularly with a soft damp cloth and mild soap.
NOTES:
– Do not use any strong chemicals inside the socket.
– Avoid use of oils on the skin, such as Vaseline or oil moisturizers.
– Avoid dirt or fluids from coming in contact with the electrode.
8