Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AC Power
The charging case has an auto-ranging power supply that can work with an input voltage range of 100-240 VAC, 50/60 Hz.
AC plug
Connection
AC Live
AC Neutral
AC Ground
DMX Linking
The WELL Gobo will work with a DMX controller using a wireless DMX connection. A DMX Primer is available from
www.chauvetprofessional.com.
DMX connection
The WELL Gobo uses a wireless DMX data connection for its DMX personalities: 1Ch, 2Ch, 3Ch, and 6Ch. See the User
Manual for information about connecting and configuring the product for DMX operation.
Wireless Operation
In optimal conditions, the WELL Gobo can operate up to 300 m (900 ft) away from the W-DMX transmitter. The W-DMX
receiver in the WELL Gobo must be paired with the W-DMX transmitter for wireless operation.
Initial setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the WELL Gobo within 300 m from the W-DMX transmitter.
4.
Turn the WELL Gobo on.
Configuration
1.
From the WELL Gobo's control panel, go to DMX Address.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to Wireless Setting > Receive.
4.
Select Receive.
5.
Select On.
6.
Press the reset button on the W-DMX transmitter.
(The Signal Strength Indicator on theWELL Gobo will show a ϟ in front of the bars for 3 seconds while a
connection is established.)
Product pairing
If the WELL Gobo has already been paired with the W-DMX transmitter, the Signal Strength Indicator in the middle of the
OLED screen will show the strength of the signal, and the DMX channel and DMX address chosen. In this case, the
WELL Gobo is ready to work in Wireless mode.
Pairing the WELL Gobo and a new W-DMX transmitter
1.
From the WELL Gobo's control panel, go to Wireless Setting > Receive Reset.
2.
Select Yes. The Signal Strength Indicator on the WELL Gobo will show a ? in front of the bars.
3.
From the W-DMX transmitter, press <RESET> (the Signal Indicator on the transmitter will flash).
4.
Once the transmitter has found the WELL Gobo, the Signal indicator on the W-DMX transmitter will illuminate
solid.
5.
The Signal Strength Indicator in the middle of the OLED screen on the WELL Gobo will show the strength of the
signal.
W-DMX operation can be interrupted or inhibited by liquid masses between the transmitter and receiver
such as water, snow, or people. For best results, keep the area between the transmitter and receiver clear
of any liquid mass.
WELL Gobo QRG Rev. 1
QUICK REFERENCE GUIDE
Wire (U.S.)
Black
White
Green/Yellow
Wire (Europe)
Brown
Blue
Green/Yellow
EN
Screw Color
Yellow/Brass
Silver
Green
2
Publicidad
Tabla de contenido
