Kohler Vanity K-2451 Guia De Instalacion página 5

3
1
2. Install the Legs
For K-2457 model only:
IMPORTANT! Be sure the drawer has been removed before
turning the vanity over. Refer to the "Remove/Adjust the Drawer"
section of this guide.
Turn the vanity over so the bottom faces up.
NOTE: The legs must be installed opposite one another. Begin with
the back left corner, then to the front right corner for installation.
Insert a hex screw with a washer through the hole in back left
leg, then through the pre-drilled outer hole on the back left
corner.
Tighten the hex screw until there is no movement of the leg.
Install the front right leg to the front right corner in the same
manner.
Insert the shelf into the groove of each installed leg.
Install the two remaining legs in the same manner. Ensure the
shelf is positioned into the groove of each leg before securing the
hex screws.
Secure an L-bracket at each leg location, as illustrated, using the
screws provided.
Turn the vanity over onto its legs.
Kohler Co.
2
6
7
5
4
5
1049900-2-B