KTM 90108904044 Manual Del Usario página 11

1
5
5
6
7
7
7
- Mount the headlight (1) (included) onto the preassembled speedometer
bracket using the EJOT PT screws KB 50x25 (2), washers DIN 9021 A5.3
(included), and hexagon collar screw M5x20 (3).
2
3
- Check the pin assignment of the headlight and vehicle.
NOTE:
If necessary, the pins on the headlight should be repinned using a small screw-
driver or needle nose pliers.
Headlight cable wiring:
Signal
Ground
Parking light
Low beam
High beam
- Connect the headlight and turn signal to the wiring harness.
- Position the headlight with the headlight bracket and fasten using the Torx
hexagon socket screws M5x10 (4) (included) at the top, the original screws
(5) on the left and right, and 1x original washer (6) on the right.
4
- Position the headlight mask and mount using the special screw M5x12 (7)
(included).
Headlight Motorcycle wiring harness
Brown Yellow/black
White
Green Red/yellow
Blue
Brown
Red/black
11