Sharp FP-P35CX Manual De Uso página 11

DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet,
the unit will check the conditions of the air. If operation is set to ON during this
time, the CLEAN-SIGN LIGHT will alternately flash in green, orange and red.
CLEAN-SIGN LIGHT
The color changes according to the air condition.
Clean (Green)
ABOUT THE CLEAN-SIGN
• The condition of the CLEAN-SIGN depends on the room air condition
detected by the Dust Sensor when the plug is inserted into the wall outlet.
• It is possible to have a green CLEAN-SIGN with impurities in the air at the
time that the air purifier was just introduced to the room environment. After
a while, however, the base impurity rate will be adjusted to detect room air
condition correctly.
CLEAN FILTER INDICATOR LIGHT
Clean the Pre-Filter when the CLEAN FILTER Indicator Light activates.
(The indicator light will activate in about 2 months, when using the unit 24
hours daily.)
Be sure to press the MODE selection Button for 3 seconds after cleaning the
pre-filter. A long beep will be heard and the operation hours stored in the
memory will be reset. Then the Filter Indicator Light will go out automatically.
Slightly Impure (Orange) Very Impure (Red)
E-9