Troubleshooting Schedule - Husqvarna 136LiHD50 Manual De Instrucciones

Troubleshooting schedule

Control Panel
Troubleshooting takes place from the keypad.
LED display
Error LED flashes.
Error LED is lit with red light.
Battery and battery charger
Troubleshooting the battery and/or the battery charger during charging.
LED display
Error LED flashing
Error LED is lit
MAINTENANCE
Possible faults
Overload.
Temperature deviation
The power trigger and the activate
button are pressed at the same
time.
Service
Possible faults
Temperature deviation
Over voltage
Cell difference too much (1V)
Possible action
The cutting attachment is jammed.
Release the cutting attachment.
Allow the machine to cool down.
Release the power trigger and the
machine is active.
Contact your service agent.
Possible action
Use the battery in surroundings
where temperatures are between -
10 °C (14 °F) and 40 °C (104 °F).
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Remove the battery from the
battery charger.
Contact your service agent.
English – 19