Milk Parameters; Cup Heater; Alarms/Notifications - Thermoplan Nespresso AGUILA 440 Manual De Instrucciones

Menu Settings

- Milk parameters

• Milk foam settings:
- Hot Foam
- Cold Foam
• Refrigerator settings

- Cup heater

Milk Foam Settings
To change the amount of milk
foam, simply change the % of
air in the milk foam as shown
on this page:
• -10%: Less foam
• 0%: Default
• +10%: More foam
The settings for the left milk
container do not automati-
cally apply to the right milk
container. The settings for
both containers have to be
configured separately.

Alarms/Notifications

What if a "Call technician"
message appears?
Call your Nespresso repre-
sentative.
Milk parameter: Milk foam set-
tings
Press the Rinse button for 3 sec.
Enter USER MENU.
USER MENU
MILK PARAMETERS
Select MILK PARAMETERS.
Enter
MILK PARAMETERS
Hot foam left = 0.0%
Select "Hot foam left = 0.0%"
Enter
Hot foam left = 0.0%
[ -10.0 ... ◄ 0% ► ... 10.0]
Increase or decrease the amount
of air in the hot milk foam if neces-
sary. Range: -10% to 10% from
default.
Enter
MILK PARAMETERS
Hot foam left = 3.0%
Repeat this process for
Hot foam right, Cold foam left,
Cold foam right, if necessary.
Exit the menu.
Description Display message
Change water filter
Service required
Milk container(s)
Ready
empty
Milk level low
Ready
Automatic rinsing
Rinsing in progress
mode
(5 min delay)
Cleaning required in
Ready
x.yy hrs.
Cleaning required in x:yy hrs
Milk parameter: Refrigerator
settings
Press the Rinse button for 3 sec.
Enter USER MENU.
USER MENU
MILK PARAMETERS
Select MILK PARAMETERS.
Enter
MILK PARAMETERS
Refrigeration temperature = 40.0 °F
Select
"Refrigeration temperature =
40.0 °F"
Enter
Refrigeration temperature = 40.0 °F
[ 39.0 ... ◄ 40.0 °F ► ... 46.0 ]
Increase or decrease the refrigera-
tion temperature as needed or set
to DEFAULT (recommended).
Enter
Exit the menu.
LED status
Change water filter
Ready
Alternating
Service required
Ready
Alternating
Add milk
Alternating
Milk level low
Alternating
Please wait
Alternating
Cup heater
Press the Rinse button for 3 sec.
Enter USER MENU.
USER MENU
MACHINE PARAMETERS
Select MACHINE PARAMETERS.
Enter
MACHINE PARAMETERS
Cup heater = On
Select
"Cup heater = On"
Enter
Cup heater = On
◄ On ►
Select "On" or "Off"
Enter
Exit the menu.
Remarks
Immediately call your Nespresso
representative.
Immediately call your Nespresso
representative.
Milk products are locked.
Fill up the milk container(s) (in refrigera-
tor).
Clean the suction tubes to make sure
milk residue is not blocking the sensors.
Indicates that the milk container(s) will
soon be empty.
Fill up the milk container(s) (in refrigera-
tor).
Automatic rinsing of external milk system
starts 5 min after the last milk-based
beverage is prepared. "Rinsing in pro-
gress" and "Please wait" appear on the
display. LEDs start to flash 10 sec before
rinsing.
When timer ends, the machine will be
locked until cleaned.
EN
17