Thermoplan Nespresso AGUILA 440 Manual De Instrucciones página 18

Alarms/Notifications
18
Description Display message
Milk system cleaning
Ready
required
Cleaning required
Cleaning the milk
To start cleaning, press and
system
hold the cleaning button for
Milk system cleaning
Cleaning in progress 28:15
mode
Milk too warm for
Ready
best foam
Milk too warm for best foam
(43–54 °F)
Replace milk with cold
Ready
milk
Replace milk with cold milk
(above 54 °F)
Open lever
Open the lever
Preparation time too
Ready
long
Preparation too long
Preparation time too
Ready
short
Preparation too short
Heating up boiler
Heating up
Energy Saving mode
Energy saving mode:
Press any button
Maximum energy
saving mode
Brewing unit requires
BU service required!
service
CCI not connected
CCI NOT CONNECTED
Flowmeter 1 error
Call service technician
LED status
Alternating
3 sec.
Please wait
Alternating
Alternating
Ready
Ready
Alternating
Ready
Ready
Alternating
Remarks
Milk products are not available.
Start the cleaning process as described
on: ► page 14 .
Start the cleaning process as described
on: ► page 14 .
To exit the menu, press any product
button.
The display shows the remaining clean-
ing time.
Normal operation.
Milk products are still available but the
quality might be reduced.
Replace milk with cold milk at 40 °F.
Milk products are locked.
Replace milk with cold milk at 40 °F.
Lift up the lever to eject the spent
capsule.
Open the lever and try to insert a new
capsule.
Make sure the building's main water
supply is on.
If the message appears repeatedly, call
your Nespresso representative.
Open the lever and try to insert a new
capsule. The message appears if no cap-
sule is inserted, the capsule is damaged
or the edges of the capsule are folded.
If the message appears repeatedly, call
your Nespresso representative.
Slow flashing during heating.
If the message persists for more than
30 min, call your Nespresso representa-
tive.
Boiler temperature reduced.
The machine will be ready within 1 min
after pressing any product button.
To reactivate machine, press the Energy
Saving button.
For more information: ►See page 10 .
Immediately call your Nespresso repre-
sentative.
All products are blocked. Rinsing and
cleaning are still possible.
Check that the CCI connection is properly
installed. If the alarm persists, call your
Nespresso representative.
Products depending on Flowmeter 1 are
blocked. All other products are available.
Call your Nespresso representative.