Safety Warnings; Work Area - Thermoplan Nespresso AGUILA 440 Manual De Instrucciones

Safety Warnings

General Information:
Risk of Property Damage
• This equipment must be installed in accordance with applicable federal, state or local plumbing codes.
• Improper handling of the machine can result in property damage.
• This machine is designed for indoor use only. Keep it in a controlled environnement (protected from dust, moist, direct sunlight,
pests, etc.).
• Clean the machine within 24 hrs of the first milk recipe preparation or before taking it out of service for an extended period of
time. Remove and empty the capsule container, then unplug the machine. Remove and empty the milk container(s), then clean
and store with the lid open. Leave the refrigerator door open when the machine is unplugged.
• Ambient temperature must be between 60 °F and 90 °F for optimal performance.
• Place the machine on a flat, level, stable, heat-resistant and fluid-resistant surface.
• Do not place the machine where a water jet may be used for cleaning.
• Leave at least 2 in of space in front of air vents.
• Store the machine in a dust-free and dry environment, and always above 32 °F.
• The top of the machine should be at least 5 ft above the floor.
• Place the machine at least 8 in away from the user.
• Use Thermoplan cleaning accessories only.
• Never use the machine without the drip tray.
• The manufacturer does not accept any liability for consequences arising from both internal and external modifications to the
machine.
• Do not store explosive or flammable substances, such as aerosol cans with a flammable propellant, inside the machine.
• Never use the cup heater for drying wet cups due to risk of electric shock.
• Always place cups upside-down to ensure good heat transfer.
SAVE THIS INSTRUCTIONS
• Pass them on to any subsequent user.
• This Instruction Manual is also available as a pdf at nespresso.com/pro
Presentation
The safety instructions in this document are presented as
follows:
1 2 3 4
5
6
1 Safety symbol 4 Impact
2 Safety signal word 5 Specified safety symbol
3 Source 6 Prevention
Safety Signal Words
The following warning messages are used in this manual:
Indicates a hazardous situation
WARNING
which, if not avoided, could result
in death or serious injury.
Indicates a hazardous situation
CAUTION
which, if not avoided, could result
in minor or moderate injury.
Indicates information considered
NOTICE
important but not hazard-related.
Hint
Indicates information to help the reader use the equipment
properly.
Safety Symbols
The following safety symbols are used in this manual:
The warning triangle appears where failure to observe
the safety instructions may result in risks to the user or
the machine.
Warning:
Electric shock
Warning:
Risk of scalding
Warning:
Risk of bruising
Instruction:
Wear gloves
Instruction:
Wear goggles
General Information

Work Area

• Keep your work area clean and tidy. Unorganized and poorly
lit work areas can lead to accidents.
• Only operate the machine in a hygienic and ergonomic envi-
ronment. The user should have enough space to work and the
work area should be well lit.
EN
7