koban KPA-11 Instrucciones Operativas página 62

3. The clamp meter LCD will display the reading.
DC/AC Voltage Measurements
1. Insert the black test lead into the negative COM terminal
and the red test lead into the positive V terminal.
2. Set the function switch to the V position.
3. Select AC or DC with the MODE button.
4. Connect the test leads in parallel to the circuit under test.
5. Read the voltage measurement on the LCD display.
Resistance and Continuity Measurements
Insert the black test lead into the negative COM terminal
1.
and the red test lead into the positive terminal.
Set the function switch to the
2.
Use the multifunction MODE button to select resistance.
3.
Touch the test probe tips across the circuit or component
4.
u n d e r
disconnect one side of the device under test so the rest
o f t h e
with the resistance reading.
www.grupotemper.com
t e s t .
c i r c u i t
1000A AC CLAMP METER
•)))
I t i s
w i l l n o t
KPA-11
position.
b e s t t o
i n t e r f e r e
11