EN
Husqvarna AB has a policy of continuous product
development and therefore reserves the right to modify the
design and appearance of products without prior notice.
Read through the Operator's Manual carefully and
understand the content before using the machine.
These instructions supplement the instructions
that were included with the machine. For other
procedures, please refer to the operating
instructions for the machine.
The J-handle set contains the
following parts:
Loop handle:
1 loop handle
1 spacer loop handle
1 washer
1 screw M6x40
J-handle:
1 J-handle
3 screws M5x16
1 harness
1 suspension ring
1 grass blade
1 support cup
1 support flange
1 nut
1 box spanner
1 transport guard
NOTE! The trimmer guard must be replaced with the
accompanying combination guard if a grass blade is fitted to
the machine.
!
WARNING!
Saw blades must not be fitted on a
machine equipped with a J-handle.
2
- English
CONTENTS
CONTENTS
List of contents .................................................................... 2
List of contents