Tool Use And Care; Specific Safety Rules For Band Saw; Features - Urrea SB1018 Manual De Usuario

TOOL USE AND CARE

Do not force the power tool. Use the correct
tool for the application. The correct tool will do
the job better and more safely at the rate that it
was designed to work at.
Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power source be-
fore making any adjustments, changing acces-
sories or storing the tool. This preventive safety
measures reduce the risk of accidental starting
of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and differential switch
when you are using an electric equipment.
SERVICE: tool service must be performed only
by qualified repair personnel. Service or main-
tenance performed by unqualified personnel
could result in a risk of injury.
SPECIFIC SAFETY RULES FOR
BAND SAW
1. Always allow the band saw blade to stop be-
fore removing scrap pieces from table.
2. Always keep hands and fingers away from the
blade.
3. Never attempt to saw stock that does not
12
have a flat surface, unless a suitable support is
used.
4. Always hold material firmly and feed it into
the blade at a moderate speed.
5. Always turn off the machine if the material is
to be backed out of an uncompleted out.
6. Adjust the upper guide about "1/8" above the
material being cut.
7. Check for proper blade size and type for
thickness and type of material being cut.
8. Make sure that the blade tension and blade
tracking are properly adjusted.
9. Make "relief" cuts before cutting long curves.
10. Release blade tension when the saw will not
be used for a long period of time.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. Quick release rod
2. Blade tracking knob
3. Blade tension handwheel
4. Guard lifting handwheel
5. Upper door
6. Switch
7. Rip fence assembly
8. Belt tension handwheel
9. Dust port
10. Upper guide
11. Bottom dust port
12. Table