Technical Data; Machine Assembly; Adjustment - Urrea SB1018 Manual De Usuario

TECHNICAL DATA

SB1018
THROAT DEPTH
BLADE SPEED
MOTOR POWER OUTPUT
CUTTING DEPTH
TABLE TILT
BLADE LENGTH
BLADE WIDTH
NETT WEIGHT

MACHINE ASSEMBLY

The machine is supplied partly assembled. Prior to
use, further assembly is required.
When unpacking the machine the following com-
ponents are included for the initial assembly.
A few elements will be disassembled from the ma-
chine main structure due to packaging and ship-
ping requirements.
These loose parts should be installed as follows.
ATTENTION: Please tighten all bolts and nuts
absolutely. Otherwise, may cause machine wob-
ble or serious injury to the operator or other
persons.
FITTING WORKING TABLE (FIG. 1)
• With the help of another person, lift the working
table onto the trunnion.
• Mount the working table to the trunnion using
the supplied (4) hex bolts and (4) washers.
• Using hex socket screw 1, washer 2 and leveling
plate 'A' for the working table flatness.
• Install the fence guide rail 'B' and the fence scale
'C' as the pictures shown.
Fig. 1
C
B
INSTALL RIP FENCE
Install the rip fence as the picture shown, then set
the fence block 'A' (Fig. 2) along the guide rail 'B'
(See Fig. 1).
465 mm
400-500/900-1100 m/min
2200 W
285 mm
0-45°
3623 cm
6-38 mm
165 kg
A
2
1
E N G L I S H •
Fig. 2
FITTING CRANK HANDLE
Attach the big crank handle 'A', 'B' separately to
the frame as the picture shown. (Fig. 3)

ADJUSTMENT

SETTING TABLE SQUARE TO SAW BLADE
CAUTION: before carrying out any adjustments
or maintenance ensure that the machine is iso-
lated and disconnected from the electricity supply.
SETTING TABLE SQUARE TO BLADE (FIG. 4)
Fig. 4
A
B
The table may be set at 90 degree to the blade
by adjusting the table stop screw under the table.
The table stop screw rests on the top of the lower
U s er 's M an u al
A
Fig. 3
A
B
13