Safety Procedures And Notes Before Switching The Machine On; Rotine Inspections - Skymsen CR-4L Manual De Instrucciones

4.2 Safety Procedures and Notes before Switching the Machine ON

IMPORTANT
Carefully read ALL INSTRUCTIONS of this manual before turning the machine ON.
Be sure to be familiar with the instructions and that you have well understood
all information contained in this manual. If you have any question contact your
supervisor or your nearest Dealer.
4.2.1 Dangerous
An electric cable or electric wire with damaged jacket or bad insulation could cause
electrical shocks as well as electrical leak. Before use, check conditions of all wires and
cables.
4.2.2 Warnings
Be sure ALL INSTRUCTIONS in this manual have been thoroughly understood. Every
function and operational procedure have to be very clear to the operator. Contact your
nearest Dealer for further questions.
Any manual command (switch, button or lever) shall be given only after being sure it is the
correct one.
4.2.3 Cautions
Power cables shoud have size enough to support the electric power used
Cables that stays in the floor or with the machine must be protected to avoid circuit
shorting
4.3 Routine Inspections
4.3.1 Warnings
When checking the tension of the belts or chains, DO NOT introduce your fingers between
the belts and the pulleys and nor between the chain and the gears.
Check if motors and sliding or turning parts of the machine produce abnormal noises.
Check the tension of the belts and chains and replace the set when belt or chain show
signs of being worn out.
14