PEERLESS CM850 Instalación Y Montaje página 10

Attach and tighten two support brackets (C) to inside of interface plate (A) and wall plate (B) using two sets of
4
1/4-20 x 1" round phillips head screws (U), 1/4" flat washers (X) and 1/4-20 flanged serrated locknuts (V).
Repeate for remaining interface plate then tighten all fasteners.
NOTE: Support bracket flanges must face inward as shown.
Align wall mount assembly (G) with interface plates (A)
5-1
to determine location of cage nuts (W) used to secure
wall mount assembly (G) to interface plates. Install
cage nuts from rear side of interface plates (A) as
shown in figure 5.1.
W
fig 5.1
B
A
A
G
X
U
FLANgE (C) FACES UP
Attach wall mount assembly (G) to interface
5-2
plates (A) using eight 1/4-20 x 1" round
phillips head screws (U) and 1/4" flat
washers (X) through slots into cage nuts as
shown in figure 5.2.
U
X
V
FLANgE (C) FACES DOWN
V
SLOT FACES WALL PLATE
X
U
MOUNTINg SURFACE
NOT SHOWN FOR CLARITy
fig 5.2