Attaching Interface Plate - PEERLESS CM850 Instalación Y Montaje

Attaching Interface Plate

Attach interface plate (A) to wall plate (B) using one 1/4-20 x 1" round phillips head screw (U), 1/4" flat washer (X)
2
and 1/4-20 flanged serrated locknut (V) as shown in fig 2.1 or 2.2 for interior corners or fig 2.3 and 2.4 for exterior
corners. Repeat for opposite interface plate.
NOTE: Be sure top flange of interface plate (A) rests on top flange of wall plate (B).
NOTE: Do not fully tighten fasteners.
LEFT INTERIOR CORNER
A
fig. 2.1
LEFT EXTERIOR CORNER
B
Snap installation tab off of wall mount assembly (G).
3
G
INSTALLATION TAB
U
X
V
B
U
X
V
A
fig. 2.3
RIGHT INTERIOR CORNER
U
X
V
B
fig. 2.2
RIGHT EXTERIOR CORNER
U
X
V
A
fig. 2.4
A
B