PEERLESS CM850 Instalación Y Montaje página 14

• Always use an assistant or mechanical lifting equipment to safely lift and position the plasma television.
Mounting and Removing Flat Panel Screen
9
Hook adapter brackets (E or F) onto adapter plate (D), then slowly swing screen in as shown.
Turn screws clockwise at least six times to prevent screen from being removed as shown in
detail 1. Tighten using 4 mm security allen wrench (T).
Screen can be adjusted horizontally if desired.
NOTE: To lock the screen down, tighten screws to adapter plate as shown in detail 1.
To remove screen from mount, loosen screws, swing screen away from mount, and lift screen
off of mount.
D
SCrEWS
DETAIL 1
Screen can tilt 5° or 10° forward.
10
NOTE: Screen must be securely attached to mounting plate with all fasteners before adjusting tilt.
To tilt screen 5° forward, lift and pull mounting plate forward until middle notch rests on M6 screw as shown in figure
10.1. Tighten M6 screw (both sides) and M10 screws (both sides).
To tilt screen 10° forward, lift and pull mounting plate forward until rear notch rests on M6 screw as shown in figure
10.2. Tighten M6 screw (both sides) and M10 screws (both sides).
NOTE: For security models, tighten M6 screw using security allen wrench (T). For all M10 screws, use 6 mm allen
wrench (not included).
SCrEEn
fig. 10.1
WARNING
E or F
M6 SCREW
MOUNTINg
PLATE
M10 SCREW
5° tilt
D
M6 SCREW
SCrEEn
fig. 10.2
MOUNTINg
PLATE
M10 SCREW
10° tilt