Back View - PEERLESS CM850 Instalación Y Montaje

Roll can be adjusted 1° clockwise or
11
counterclockwise.
To adjust roll, loosen M10 x 15 mm screws (I)
slightly, leaving them snug. Level screen and
adapter brackets, then tighten screws (I) .
NOTE: When adjusting roll, screws should be
retightened as indicated in step 8.
M10 x 15 MM SCREW (I)

BACK VIEW

Optional: To lock one sliding arm of mount in place,
13
slide locking tab (H) over top or bottom of sliding arm
and attach to mount using one M5 x 10 mm screw (M)
and one spacer (N).
NOTE: Full assembly/screen not shown for clarity.
NOTE: MOUNTINg PLATE SHOW
WITHOUT FULL WALL MOUNT
ASSEMBLy FOR CLARITy.
SLIDINg ARM
Optional: To lock mount in closed position, insert
12
one M5 x 40 mm screw (L) into tapped hole in
either top or bottom of flat plate.
NOTE: Full assembly/screen not shown for clarity.
TAPPED HOLE
Slide one mesh sleeve (R) over each cable. Use
14
cable ties (O) to tighten both ends of mesh sleeves
to cables.
NOTE: Loop cable ties through cable mounts and
tighten cable and mesh sleeve to cable mounts.
M
H
N
L
TAPPED HOLE
FLAT
PLATE
R
CABLE
MOUNTS
O