Seating The External Bead; Hardware And Software Requirements For Update/Data Upload Pc - Magneti Marelli TPMS CONNECT EVO Guía Rápida

18.6. Seating the external bead

Place the sensor nearly at 9 o'clock with respect to head. These tires normally have
stiff sidewalls and it might be convenient to use pressure rollers (positioned as shown
in the picture) to pry the bead under the wheel well edge.
Slowly rotate the wheel until seating the bead.
Follow the instructions provided by the manufacturers of tyre changer,
tire and sensor. Inflating the tire involves potential risks to operator
safety; follow the instructions of tire and sensor manufacturers.
Check sensor for proper operation before refitting the wheel to avoid
removing the wheel again in the event the sensor needs to be
replaced.
When you have installed all four wheels, check that sensors are in
the correct positions using the "Location Test" function (see
paragraph 12.5 of this manual.)
19. Hardware and software requirements for update/data
upload PC.
26