Dishwasher Control Section; Dishwasher Feedback Section; Canceling A Cycle - KENMORE ELITE 722.1469 Serie Manual De Uso Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Delay Hours
Use this option to run the dishwasher during off-peak hours. Contact your local utility provider to determine off-peak hours.
Delaying the Start Time
1. Select a wash cycle and options.
2. Press Delay Hours to choose the number of hours to be delayed.
NOTE: The delay time can be set from 1 to 19 hours, in one-hour increments.
Control Lock Option
The Control Lock feature helps prevent settings from being changed during a cycle. Selecting this feature locks all of the
buttons, except for the Power button, on the control panel. This feature does not lock the door.
Activating the Control Lock:
Press and hold Rinse Options and Spray Power for three seconds. The Control Lock indicator( ) illuminates on the display once
the Control Lock is activated. Repeat to deactivate.
NOTE: The dishwasher cannot start if the control is locked.
Cycle Indicators and Time Display
After you start the dishwasher, the display counts down the time.
When you select the Delay option, the time display will give the number of hours followed by an "H".
Selecting Cycles and Options
1. To repeat the same cycle/options used on previous cycle, close the door. To change cycle, select desired cycle.
2. Select the desired options, then close the door to start the cycle. Not all options are available for every cycle.
Turning OFF/ON the Button and End of Cycle Chimes
Press and hold China Gentle and Express Wash for three seconds to toggle sound On and Off. The sound will not deactivate
for cycle interruption or service required messages.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold China Gentle and Mixed Load for three seconds. The drain pump activates and the cycle cancels.
3. The display shows dr and the dishwasher drains. Once the dishwasher finishes draining, the power turns off.
NOTE: If the dishwasher is powered on and no cycle is selected for four minutes, the dishwasher powers off.
18

Dishwasher Control Section

Dishwasher Feedback Section

The indicators glow when the dishwasher is washing, drying, sanitizing, and at cycle completion.
They also glow when the control is locked and/or the delay option is selected.
The Status Display is used to follow the progress of the dishwasher cycle and to show other
information.
Estimated cycle time is displayed in hours and minutes as you make cycle and option selections.

Canceling a Cycle

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

1469 serie

Tabla de contenido