Prepare The Site - Kohler K-97630-NY Instrucciones De Instalación

1. Prepare the Site

2x4 Bracing
65"
(1651 mm)
11" (279 mm) Min
15" (381 mm) Max
IMPORTANT! Waterproof wallboard backing material is recommended.
Install the rough plumbing for the bath and shower components.
Check the studs for plumb. Studs should be within 3/8" (10 mm) of plumb. Shim if necessary.
The ledge of the locker unit can be used as a footrest. The recommended footrest height is 12" (305 mm) to 16" (406
mm), from the floor of the shower to the ledge of the locker unit.
Determine the height of the enclosure and the locker unit.
Install 2x4 bracing where the locker unit will be placed following the dimensions shown above.
To determine the height of the bottom bracing, subtract 1" (25 mm) from the desired height of the footrest.
Install wallboard backing material over the locker unit opening with the same dimensions as the 2x4 bracing cutout.
1484883-2-A
K-97630: 9" (229 mm)
K-97631: 14-1/2" (368 mm)
Wallboard Backing
65"
(1651 mm)
11" (279 mm) Min
15" (381 mm) Max
4
K-97630: 9" (229 mm)
K-97631: 14-1/2" (368 mm)
Kohler Co.