OVE BETHANY Manual Del Usuario página 30

INSTALLATION DE LA BARRE DE SUPPORT
1-2. Completely remove the guide (Q) and the support bar (F).
3. Drill a pilot hole for the sliding door guide (Q) using a ø1/8" (3mm) drill bit.
4. Place the 2 support bar's anchors (D & D1) back on their wall mark, then mark their holes on the wall.
5-6. Drill a hole on the center marks with a ø5/16" (8mm) drill bit and insert the wall anchors (HH) using a
rubber mallet. Fix the center fitting on the support bar's anchor (D & D1) using the screws (GG).
Note: Avant de continuer, placez la porte (J) à l'intérieur de l'enclave de la douche. Cela facilitera les
1
C
Q
3
ø1/8"
3mm
5
ø5/16"
8mm
étapes suivantes!
30
2
F
C
4
&
D
D1
6
HH
&
D
D1
GG