1-2. Insert the fixed panel's bottom seal strip (R) at the base of the fixed panel (C). Cut the surplus part with a
cutter to size, about 1 9/16" (40mm) from the panel's edge.
Note: The wall track (B & B1) allows you to adjust the position of the fixed panel (C). Adjusting the
depth and/or giving the glass panel a slight angle allows for precise alignment with the door.
3-4. Place the fixed panel (C) into the wall track (B) and the sliding door guide (Q).
5-6. Make sure the door panel's top track (S) is at the door side. Slide the fixed panel's top seal strip (G) into
the support bar (F).
1
C
R
3
B
5
F
S
FIXED PANEL INSTALLATION
1 9/16"
40mm
R
C
10
2
C
R
4
C
Q
6
F
G