Listening To The Radio; Presetting Stations Automatically - Panasonic SC-HC28 Instrucciones De Funcionamiento

Listening to the radio

You can preset up to 30 channels.
Preparation
≥ Make sure that the antenna is connected. (l 5)
≥ Turn the unit on.
≥ Press [RADIO] to select "FM".
≥ A station previously stored is overwritten when another
station is stored in the same channel preset.

Presetting stations automatically

1
Press [PLAY MENU] to select "A.PRESET".
2
Press [3, 4] to select "LOWEST" or "CURRENT"
and then press [OK].
LOWEST:
To begin auto preset with the lowest frequency
(FM 87.50).
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to "Manual tuning and
presetting".
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Listening to a preset channel
Preparation
1 Press [PLAY MENU] repeatedly to select
"TUNEMODE".
2 Press [3, 4] to select "PRESET" and then press
[OK].
Press [:/6] or [5/9] to select the channel.
8
RQT9734
∫ Manual tuning and presetting
Select a radio broadcast.
1
Press [PLAY MENU] repeatedly to select
"TUNEMODE".
2
Press [3, 4] to select "MANUAL" and then press
[OK].
3
Press [:/6] or [5/9] to tune to the
required station.
≥ To start automatic tuning, press and hold [:/6],
[5/9] until the frequency starts scrolling. Tuning
stops when a station is found.
To preset the channel
4
While listening to the radio broadcast
Press [OK].
5
Press [3, 4] to select the channel and then press
[OK].
∫ To improve FM sound quality
1
While receiving FM broadcasts, press
[PLAY MENU] repeatedly to select "FM MODE".
2
Press [3, 4] to select "MONO" and then press
[OK].
≥ This setting can be preset and memorised. To do so,
continue to step 4 of "Manual tuning and presetting".
≥ Select "STEREO" in step 2 to return to stereo broadcasts.
≥ "MONO" is cancelled if the frequency is changed.
≥ If "MONO" is selected, regardless of the type of signal this
unit is receiving, "FM MONO" is displayed. (l below)
∫ To display the current signal status
Press [PLAY MENU] to display "FM STATUS" and then
press [OK].
"FM ST": The FM signal is in stereo.
"FM": The FM signal is in monaural.
≥ "FM" is also displayed even if this unit is not tuned to a
station.
∫ To display RDS text data
Press [DISPLAY] to display the text data.
≥ Each time you press the button:
"PS": Programme service
"PTY": Programme type
"FREQ": Frequency display
≥ "STEREO" is displayed when this unit tunes to a stereo
broadcast.
≥ The unit can display the text data transmitted by the radio
data system (RDS) available in some areas. (RDS displays
may not be available if reception is poor.)