Safety Notes; Important Notes; Multi-Protocol Operation - Trix Ardelt 57t Manual De Instrucciones

Safety Notes

• This model is only to be used with the operating system it
is designed for.
• Digital max. 22 volts AC.
• This model must never be supplied with power from more
than one power pack.
• Please make note of the safety notes in the instructions
for your operating system.
• WARNING! Sharp edges and points required for operation.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! This product contains magnets. Swallowing
more than one magnet may cause death in certain circum-
stances. If necessary, see a doctor immediately.
• The LEDs in this item correspond to Laser Class 1 accor-
ding to Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• The warranty card included with this product specifies
the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
• The minimum usable radius is 437 mm / 17-1/4".
12

Multi-Protocol Operation

The decoders are multi-protocol decoders. These decoders
can be used under the following digital protocols: mfx, DCC
or MM.
Address set at the factory: DCC 03 / MM 77
The digital protocol with the most possibilities is the highest
order digital protocol. The sequence of digital protocols in
descending order is:
Priority 1: mfx
Priority 2: DCC
Priority 3: MM
Note: If two or more digital protocols are recognized in the
track, the decoder automatically takes on the highest value
digital protocol.For example, if mfx & DCC are recognized,
the mfx digital protocol is taken on by the decoder. Individual
protocols can be deactivated with Parameter CV 50.
Note: Please note that not all functions are possible in all
digital protocols.
Notes on digital operation
• The operating instructions for your central unit will give
you exact procedures for setting the different parame-
ters.
mfx Protocol
Addresses
• No address is required; each decoder is given a one-
time, unique identifier (UID).
• The decoder automatically registers itself on a Central
Station or a Mobile Station with its UID.
• Name set at the factory: Ardelt 57t 6664