Maintenance; To Perform Maintenance On The Attachment; To Check The Chain Drive Sprocket - Husqvarna PA1100 Manual Del Usuario

Ocultar thumbs Ver también para PA1100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
To check the saw chain
Do a check of the saw chain daily.
1. Make sure that there are no cracks in rivets and
links.
2. Examine if the saw chain is rigid.
3. Compare the saw chain with a new saw chain to
examine if the rivets and links are worn.
4. Replace the saw chain if it exhibits any of the
conditions above.
5. Replace the saw chain when the length of the cutting
teeth has worn down to only 4 mm (0.16 in.)

To check the chain drive sprocket

1. Regularly check the degree of wear on the drive
sprocket. Replace if wear is excessive.
10

Maintenance

To do a check of the guide bar
1. Make sure that the oil channel is not blocked. Clean
if it is necessary.
2. Examine if there are burrs on the edges of the guide
bar. Remove the burrs using a file.
3. Clean the groove in the guide bar.
4. Examine the groove in the guide bar for wear.
Replace the guide bar if it is necessary.
5. Examine if the guide bar tip is rough or very worn.
1350 - 002 - 17.01.2020

Publicidad

Tabla de contenido
loading

Tabla de contenido