Maintenance; Inspection And Maintenance - Husqvarna 536LiP4 Manual De Instrucciones

Ocultar thumbs Ver también para 536LiP4:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Inspection and maintenance

Li-ion
Li-ion
WARNING! Always disconnect the
!
battery before any maintenace on the
machine.
IMPORTANT! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
All servicing and repair work on the machine requires
special training. This is especially true of the machine's
safety equipment. If your machine fails any of the checks
described below you must contact your service agent.
When you buy any of our products we guarantee the
availability of professional repairs and service. If the
retailer who sells your machine is not a servicing dealer,
ask him for the address of your nearest service agent.
Only use original spare parts.
Regularly check that the battery charger and the battery
are intact.
Changing chain sprocket
Contact your dealer for help if you are the least unsure
about changing the chain sprocket.
Unscrew the nut for the chip guard and remove the
guard.
26 – English

MAINTENANCE

Dismantle the clip holding the washer and the chain
sprocket.
Remove the washer.
Remove the chain sprocket and replace with a new
one.
Cleaning
Clean the machine after use.
Clean the oil tank vent with a brush.
Clean under the chip guard with a brush.
If the battery connector on the machine is dirty, clean
it by blowing them with compressed air or use a soft
brush.
Make sure the battery and battery charger are clean
and that the terminals on the battery and the battery
charger are always clean and dry before the battery is
placed in the battery charger.
Keep the battery guide tracks clean.
Clean plastic parts with a clean and dry cloth.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

536lipt5

Tabla de contenido