Price Pfister GENESIS 533 Serie Guia De Instalacion página 2

Thank you for purchasing this Price Pfister kitchen faucet. All Price Pfister products are carefully engineered, and factory tested to provide long
trouble-free use under normal conditions. This kitchen faucet is easy to install using basic tools and our easy to follow illustrated instructions.
If you have any questions regarding your kitchen faucet installation call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding.
Price Pfister recommends calling a professional if you are uncertain about
installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are
usually found under the sink or near the water meter. If you are replacing an
existing faucet, remove the faucet from the sink and clean the sink surface
thoroughly.
3
3 TOOLS RECOMMENDED
• PTFE plumber's tape or thread sealant
• Slotted screwdriver • Phillips head screwdriver
• Adjustable wrench • Flashlight
Your installation may require new supply lines and/or shut-off valves or other
additional tools.
4
A
B
1 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, please check to ensure that all of the following items
are included with your faucet:
A Faucet body
C Deckplate
E Pull-out hose
F Bag with weight & spring clip.
G Bag with 2 mounting screws, 2 wing nuts & bottom plate.
H Rubber gasket, lockwasher & brass nut.
If any of these items are missing, please contact Price Pfister Consumer Services
at 1-800-Pfaucet (1-800-732-8238).
• Plumber's putty
• Pliers
• Cloth
H
D C
E
B Spray head
D Mounting Ring
ENGLISH
INSTALLATION:
Your faucet can be installed with or without the deck plate:
For 3-hole installation using the deck plate:
For 1-hole installation using the single post:
5
5A
5 INSTALLING OPTIONAL DECKPLATE
(For single post mount, go to step 8)
G
Place screws (5A) into deck plate slots. Set plastic bottom plate (5B) over the
center hole on the sink, rounded edges up. Put a bead of plumbers' putty around
the inside bottom edge of deck plate (5C). Install the deck plate (5C) over the
three holes in your sink.
6
F
6 SECURING DECKPLATE TO DECK
From underneath sink, hand tighten wing nuts ( 6A ). Caution: do not over-
tighten wing nuts. Remove any excess putty from around the outside edge
of the deck plate ( 6B ).
2
Go To Step 5
Go To Step 8
5B
6A
6B
6A
5C
5A