Price Pfister GENESIS 533 Serie Guia De Instalacion página 3

7
7H
7E
7B
7 INSTALLING THE FAUCET USING DECKPLATE
Insert the faucet supply tubes (7A) and Hose (7B) through the optional deck plate
(7C). From underneath the sink, place large rubber gasket (7D), lockwasher (7E)
and large brass nut (7F) over supply tubes (7A) and hose (7B). Thread loosely
onto faucet shank (7G). Align the faucet, making sure that the spout and handle
swing equally in both directions. Tighten faucet firmly to sink.
Note: Do not remove thin protective plastic bag (7H).
STOP
8
8G
8F
8D
8B
8 SINGLE POST MOUNT INSTALLATION
(Do not use optional deck plate, plastic bottom plate, screws, or wing nuts.)
Insert tubes (8A) and hose (8B) through center hole of sink. From underneath
the sink, place large rubber gasket (8C), lockwasher (8D) and large brass nut
(8E) over supply tubes (8A) and hose (8B). Thread loosely onto faucet shank
(8F). Align the faucet, making sure that the spout and handle swing equally in
both directions. Tighten faucet firmly to sink.
Note: Do not remove thin protective plastic bag (8G).
7C
7G
7D
7F
7A
Go To Step 9
8C
8E
8A
ENGLISH
9
9C
9 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Faucet Inlets (9A), approximately three inches apart
(See figure 15). Connect water Supply Lines (9B) to Faucet Inlets (9A). Hot water
supply line goes to hot inlet fitting indicated by red tag (9C). (Supply lines not
included). Follow manufacturer's instructions when installing supply lines.
10
10D
10A
10 ATTACHING HOSE
Remove the tape from hose end (10A). Be sure washer (10B) stays on small end
of hose (10C). From below sink, hold hose end (10C) with a 9 / 16 " wrench and
tighten tube coupling (10D) with another 9 / 16 " wrench. Do not twist Hose!
11
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below
the sink.
3
9A
COLD
HOT
9B
10B
10C
10C
10D
10A