Remington HC4250 Manual Del Usuario página 5

Ocultar thumbs Ver también para HC4250:
Tabla de contenido

Publicidad

Use the clipper without any fixed combs for trimming hair close to the skin.
This will trim hair to 1mm, holding the clipper so the blades are perpendicular to the skin will trim hair
to 0.5mm.
TO ATTACH A COMB
Hook the front edge of the comb to the front teeth of the wide trimmer blade. Then push the back of
the comb down until it snaps in place.
TO REMOVE THE COMB
Push up the back of the comb until it clicks off the clipper blade.
INSTRUCTIONS FOR CUTTING HAIR
The QuickCut Clipper's ergonomic design provides many different ways of holding the clipper in use.
For clipping the top of the head (see fig. 1).
For clipping the back of the head (see fig. 2).
For clipping the sides of the head (see fig. 3).
For detailing (see fig. 4).
For even cutting, allow the comb attachment/blade to cut its way through the hair. Do not force it
through quickly. If you are cutting for the first time, start with the maximum comb attachment.
For one all over cut length, attach the desired guide comb and slowly guide the clipper through the
hair against the direction the hair normally grows.
Remove the guide comb. To produce a clean straight line at the sideburns and the base of the neck,
reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly
touching the skin and then work downwards.
The following instructions are for those users who want different trimming lengths on the sides, back and
top of the head
STEP 1 – NAPE OF THE NECK
Set the comb to 3mm or 6mm.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the head at the
base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time.
STEP 2 – BACK OF THE HEAD
With the comb set at 9mm or 12mm, cut the hair at the back of the head.
STEP 3 – SIDE OF THE HEAD
With the comb set at 3mm or 6mm, trim sideburns. Then change to the longer 9mm guide comb and
continue to cut the top of the head.
STEP 4 – TOP OF THE HEAD
Use the longer length comb attachment and set it to 12mm or 15mm then cut hair on top of the head
against the direction in which the hair normally grows.
STEP 5 – THE FINISHING TOUCHES
Use the clipper without an attachment comb for close trimming around the base and sides of the neck
and around the ears.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at
right angles to the head, tips of the blades lightly touching the skin and then work downwards.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5

Publicidad

Tabla de contenido
loading

Tabla de contenido