Disposal Of The Product - Allmatic MICROCAP 16 Manual Del Usuario

indicate the deactivation of the sensor or emits 3 beeps to indicate the activation of the sensor.
2. Release the key of the transmitter.
5.6 Control unit behaviour during the alarms (wind, rain, snow, disconnection)
The presence of an alarm will immediately close the awning / rolling shutter and block the operation of the transmitters
for:
• 2 minutes after the finishing of the rain alarm. The alarm condition is signaled with 3 beeps after a user command.
• 12 minutes after the finishing of the wind alarm. The alarm condition is signaled with 2 beeps after a user command.
• 30 minutes after the finishing of the snow alarm. The alarm condition is signaled with 5 beeps after a user command.
The detection of the snow (snow alarm) occurs in different ways depending on the type of sensor used:
• Sensor powered from the mains (KAIROS): presence of rain and temperature below 4°C (sensor with heater).
• Sensor powered by photovoltaic panel (KAIROS SA): only temperature lower than 2°C regardless of the presence of
rain (sensor not equipped with heater).
• AXEM sensor: inclination of the awning higher than 2° compared to the memorized position.
In case the radio communication between the sensor and the control unit is missing for more than 4 minutes, the control
unit closes completely the awning / rolling shutter and remains in disconnection alarm until the reconnection of the
sensor.
During the state of alarm it is possible to carry out the radio learning, but it is not possible to carry out any movement
until the control unit does not exit from the alarm. The alarm condition is signaled after a user command.
6
RESET
1. Press and hold the learning button. After 7 seconds, the control unit emits a continuous beep.
2. Release the learning button, the control unit emits 5 beeps.
All the transmitters have been erased and the settings have been reset at factory settings.
7

DISPOSAL OF THE PRODUCT

This product is an integral part of the automation, and therefore, they must be disposed of together. As for the installation
operations, at the end of the life of this product, the dismantling operations must be performed by qualified personnel.
This product is made from different types of materials: some can be recycled, others must be disposed of. Please inform
yourselves on the recycling or disposal systems provided for by the laws in force in your area, for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances which, if dispersed in the environment,
may cause serious harm to the environment and human health.
As indicated by the symbol at the side, it is forbidden to throw this product into domestic refuse. Therefore, follow the
"separated collection" instructions for disposal, according to the methods provided for by local regulations in force,
or redeliver the product to the retailer at the moment of purchase of a new, equivalent product. CAUTION! – the
regulations in force at local level may envisage heavy sanctions in case of abusive disposal of this product.
WARRANTy
In compliance with legislation, the manufacturer's warranty is valid from the date stamped on the product and is restricted to
the repair or free replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or
manufacturing defects. The warrenty does not cover damage or defects caused by external agents, faulty maintenance, overloading,
natural wear and tear, choice of incorrect product, assembly errors, or any other cause not imputable to the manufacturer. Products
that have been misused will not be guaranteed or repaired. Printed specifications are only indicative.
The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environmental interference. The
manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective products,
are only those responsibilities that come under Italian law.
4/4
ALLMATIC S.r.l
Via dell'Artigiano, n°1 – Z.A. - 32026 Borgo Valbelluna
Belluno – Italy Tel. 0437 751175 – 751163 r.a.
www.allmatic.com - E-mail: info@allmatic.com
ITA ENG FRA ESP DEU POR
6-1622108 rrev1 05/03/2020