Operation - Swissmex 319310 Manual Del Operacion

4.- Pass the pump handle through the base of the tank fixing it to the connecting rod with a flat washer and a lock pin
"C" and on the other end with a lock washer and a cotter pin.
5.- Assemble the nozzle to the spray lance. Lightly tighten without tools.
6.- Assemble the spray lance to the shut-off and tighten manually. Make sure the gasket is in place.
1
3
4
5
6
189335

OPERATION

4.
Compression sprayer:
Mix the solution in a separate container following the instructions of the product manufacturer.
Unscrew the pumping tube and remove it from the tank.
Pour the pre-mixed solution up to the indicated level marked in the tank.
Replace the pump tube and screw it tightly, then pressurize the unit.
Hold the sprayer by the handle or place it on the shoulder with the carrying strap and start applying.
Turn the nozzle to change the spray pattern (Solvent models 319310, 320305 & 322315).
2
4
189310
NOTE:
The pump tube must be tight
firmly otherwise the applicator
will leak and will not hold
pressure.
NOTE:
To ensure the best performance
use only "SWISSMEX-RAPID"
original spare parts.