Reprocessing The Mask Between Patients - ResMed Quattro Air NV Guia Del Usuario

WARNING
Always follow cleaning instructions and use mild soap. Some
cleaning products may damage the mask, its parts and their function,
or leave harmful residual vapours that could be inhaled if not rinsed
thoroughly.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, discoloration, tears etc.), the component should be
discarded and replaced.
Daily/After each use:
•
Disassemble the mask components according to the disassembly
instructions.
•
Thoroughly clean the separated mask components (excluding
headgear), by gently rubbing in warm (approximately 30°C) water
using mild soap.
•
To optimise the mask seal, facial oils should be removed from the
cushion after use.
•
Inspect each component and, if required, repeat washing until visually
clean.
•
Rinse all components well with drinking quality water and allow to air
dry out of direct sunlight.
•
When all components are dry, reassemble according to the
reassembly instructions.
Weekly:
•
Handwash the headgear. It may be washed without being
disassembled.

Reprocessing the mask between patients

When using between patients, these masks must be reprocessed
according to instructions available on ResMed.com/downloads/masks.
English 5