Recommendations And Suggestions - Beko CFB 9463 X Manual Del Usuario

1

Recommendations and Suggestions

The Instructions for Use
apply to several ver-
sions of this appliance.
A
Accordingly, you may find
descriptions of individual
features that do not apply
to your specific appliance.
1.1 Installation
The manufacturer will not be held
liable for any damages resulting
from incorrect
installation.
The minimum safety distance
•
between the cooker top and
the extractor hood is 650 mm
(some models can be installed
at a lower height, please refer
to the paragraphs on working
dimensions and installation).
Check that the mains voltage
•
corresponds to that indicated on
the rating plate fixed to the inside
of the hood.
For Class I appliances, check
•
that the domestic power supply
guarantees adequate earthing.
Connect the extractor to the
•
exhaust flue through a pipe of
minimum diameter 120 mm. The
route of the flue must be as short
as possible.
4 / EN
or improper
Do not connect the extractor
•
hood to exhaust ducts carrying
combustion fumes (boilers,
fireplaces, etc.).
If the extractor is used in
•
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufficient degree
of aeration must be guaranteed
in the room in order to prevent
the backflow of exhaust gas. The
kitchen must have an opening
communicating directly with the
open air in order to guarantee the
entry of clean air. When the cooker
hood is used in conjunction with
appliances supplied with energy
other than electric, the negative
pressure in the room must not
exceed 0,04 mbar to prevent
fumes being drawn back into the
room by the cooker hood.
In the event of damage to the
•
power cable, it must be replaced
by the manufacturer or by the
technical service department, in
order to prevent any risks.
If the instructions for installation
•
for the gas hob specify a greater
distance specified above, this
has to be taken into account.
Regulations concerning the
discharge of air have to be fulfilled.
Hood / User Manual