Project Source 553401 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve at the main water supply,
disconnect the supply lines, and remove old shower head and
faucet body.
Clean and dry surface area where new shower will be mounted.
2. Place new faucet (A) through holes in top of sink. From underside,
slide mounting nuts onto threaded rods. Secure with mounting
nuts (AA).
3. Attach spray assembly hose (3.1) to the connection (3.2) beneath
the faucet by tightening the swivel nut (3.3) by hand. Be careful not
to twist the hose or overtighten the nut.
4. Loosen top of balance weight (4.1) by turning counterclockwise.
Slide weight (4.1) to desired position on spray hose, just above
hose bend on the spray head side. Re-tighten weight (4.1) to lock
into position.
Pull spray hose in and out to check for smooth operation.
5. Connect Water Supply Lines
(5.1) Use 1/2 in. IPS faucet supply lines or (5.2) use coupling nuts
(not supplied) with (5.3) ball-nose risers (not included).
Turn water supply or shut-off valve back on and check for leaks. If
leaks occur, gently tighten the faucet connections.
4
1
2
A
AA
3
3.1
3.2
3.3
4
4.1
5
1
5.1
Lowes.com
3
5.3
5.2 2