Fuel And Oil Supply - Truper MOT-3314 Instructivo

Fuel and Oil Supply

Fuel Supply for the motor
• Follow the Safety Warnings for handling fuel
(see page 5).
• Lay down the chain saw on its side so that the fuel and
oil caps face upwards.
• Wipe clean the surface of the fuel tank cap to prevent
contamination.
• Slowly loosen the fuel tank cap.
• To prevent spilling, use care to pour the fuel mix into the
tank. CAUTION Follow the fuel specifications (See
page 3).
• Before covering the fuel tank check and wipe clean the
joints.
• Set immediately the fuel tank cap. Hand-tighten the cap.
• Wipe clean all the fuel spillage.
Oil Supply for The Bar and Cutting Chain
• Use oil specified for bars, chains and the lubrication
systems, especially formulated to perform in a wide range
of temperatures without the requisite of dilution.
• The chainsaw shall use approximately one tank oil per
each of fuel tank consumed.
CAUTION
• Do not use dirty, used or contaminated
oil. The oil pump, bar or chain may get damaged.
• Lay down the chain saw on its side so that the fuel and
oil caps face upwards.
• Wipe clean the surface of the oil tank cap to prevent
contamination.
• Slowly loosen the oil tank cap.
• Use care to prevent spillages in the tank.
• Before covering the oil tank check and wipe clean the joints.
• Set immediately the oil tank cap. Tighten by hand.
• Wipe clean all the oil spillage.
9
ENGLISH