Technical Data; Fuel Specifications - Truper MOT-3314 Instructivo

Technical data

Codes
Description
Net Weight (without bar)
Bar Length
Chain Pitch
Chain Gauge
Drive Sprocket Wheel
Motor Cylinder Capacity
Motor Rated Power
(ISO 7293)
Maximum Motor Speed
Chain Speed
Motor Idle Speed
Fuel Tank
Oil Tank
Vibration
front handle
rear handle
(ISO 7505)
Work Cycle

Fuel Specifications

• The chain saw is built with an air-cooled, 2-stroke motor using unleaded gasoline, high quality self-mixing oil with fuel
stabilizer specified for air-cooled 2-stroke motor.
• The motor is certified to function with unleaded gasoline for vehicles with an 87 ([R+M]) octane-rating or higher.
• Do not use any type of pre-mixed gasoline with oil purchased in gas stations, like the one fit for motorcycles.
• DO NOT use automotive oil, nor outboard 2-stroke motor oil.
• The mix ratio shall be 32 parts gasoline per 1 part oil (ratio 32:1). Prepare the mix in a gasoline approved container. Always
mix thoroughly before pouring in the motor tank.
CAUTION Do not use fuel mix that has been stored more than 7 days. Mix only small amounts.
WARNING Never smoke near fuel or the area where gasoline is being filled up nor where the mix with
oil is being prepared or when operating the chain saw.
Unleaded
Gasoline
3,7
L
1 gallon
1
L
1 liter
To extend the useful life of the motor use
MOT-3314 MOT-4516
16615 16620
10.14 lb
14"
3/8"
6 sprockets
33 cc
1.5 Hp
64.9 ft/s
13.1 ft/s
2
14.4 ft/s
2
30 minutes' rest per each tank consumed.
2-stroke
Motor Oil
+
4
oz
+
6 capfuls
MOT-4518
16625
Chain Saw
10.8 lb
16" 18"
0,325"
0,05"
7 sprockets
45 cc
2.2 Hp
12 500 RPM
68.2 ft/s
From 2 600 RPM to 3 400 RPM
19,4 oz
11.83 oz
11.4 ft/s
2
25.2 ft/s
2
Maximum 6 hours daily.
=
=
synthetic oil for 2-stroke motors.
MOT-4520 MOT-5120
16627 16628
11.7 lb
20"
51 cc
2.7 Hp
Mix
ratio
32:1
Mix
ENGLISH
3