General Cleaning; Fuel Filter - Truper MOT-3314 Instructivo

Adjustments and
Maintenance
Air Filter Cleansing
• First, access the air filter by removing the motor
cover. Follow these steps:
• Loosen the three screws fastening the chain saw
motor cover.
• Set the chain brake.
• Lift the front side of the motor cover over the chain
brake lever.
• Lift the rear side of the motor cover over the rear
handle.
• Then pull the choke lever completely outwards to
prevent contaminating the carburetor during the cleaning
process.
• When removing the air filter use compressed air or a
brush in the uncovered area to eliminate soil and sawdust
as much as possible.
• Remove the air filter loosening the fixing screw and
turning the tip of a flat screwdriver between the filter and
its base.
• Reliant on the use time, clean the filter superficially only
tapping it against a smooth and flat surface to dislodge
most of the sawdust and dust particles.
• The air filter can also be cleaned with compressed air.
Clean on both sides.
• For a more complete cleansing wash the air filter with a
soapy solution, rinse and let dry completely before
installing back in the chain saw.
• If using compressed air to dry it, blow air on both sides
of the filter.
• Set back the air filter. Verify it matches and rests perfectly
in the base before tightening the screw.

General Cleaning

• Using a brush or compressed air clean and clear the
ventilation slots in the starter unit each time is necessary.
• Likewise, clean periodically the blades in the motor
cylinder and the ventilator blades to remove dirt.
Otherwise the motor can get damaged due to
overheating.
• Depending on the type of fuel and oil used, or the
particular functioning conditions, the exhaust orifice and
the muffler can be obstructed with coal deposits. If the
chain saw shows loss of power it will be necessary to
eliminate such deposits to restore performance. Take the
chain saw to a
Center to carry out this service.

Fuel Filter

• Check periodically the fuel filter. If contaminated or
damaged, go to a
Center to replace it.
Authorized Service
Authorized Service
Pre-filter Cleansing
• The pre-filter shall be cleaned a least each 25 tanks of
fuel used.
• To gain access to the pre-filter remove the motor cover
(the removal process is described in the previous
paragraphs).
• Remove the starter unit loosening the four screws.
• Remove the ventilator deflector.
• The pre-filter is cube made of synthetic foam. Remove
it to clean it.
• When cleaned set it back in place in the same position.
• Set back the fan deflector and the starter unit.
Starter
Unit
WARNING
• Never try to start the motor
WITHOUT assembling first all the chain saw parts.
Otherwise the parts can get fractured and shoot out
towards the operator. Can also damage the chain saw and
make the Warranty void.
Motor
Cover
Air
Filter
Fan
Defletor Fuel Filter
ENGLISH
Pre-filter
19