Bar And Chain Mounting - Truper MOT-3314 Instructivo

WARNING • Never start the motor without
installing the guide bar first, the cutting chain and the bar
guard and chain and clutch drum. If these parts are not in
place the clutch may shoot out or burst exposing the user
to severe injuries.
• Set the switch in the OFF position.
• Pull the chain brake backwards to assure it is in working
position (see page 8).
CAUTION • Wear heavy-duty protective gloves to
manipulate the chain safely and prevent cuts.
• Remove the bar mounting nuts with a combination key
or 5/8" hex key.
• Remove clutch cover and the outer plate in the guide
bar.
• Extend the chain onto a flat and clean surface in an oval
shape, together with the chain bar and straighten any
twisted link. The cutting sprockets shall face the chain
displacement direction, otherwise reverse the chain
position.
• Set the chain traction sprockets around the bar slot.
• Set the chain in a loose manner in the rear side of the
bar.
10
ENGLISH

Bar and Chain Mounting

Chain
Support
Cogwheel Tension
Pin
Straighten
Cutting
sprockets
Chain Brake
is Activated
Mounting
Bolts
Outer
Plate
Displacement Direction
Advancement
Traction
teeth